Key Features

• LH handing, sized to fit 39-1/2" x 86" opening
• Pre-glazed 1/4" tempered safety glass for commercial use
• ADA & IBC compliant entrance assembly
• Grade 1 UL Listed, ANSI/BHMA certified hardware throughout
• Architectural clear anodized finish on heavy-wall rails and stiles
• Purpose-built for steel stud + veneer façade conditions

What’s Included (Pre-Installed / Packaged)

• Alumitrex™ storefront door leaf, LH, sized for 39-1/2" x 86" opening
• 1/4" tempered safety glass, factory pre-glazed with glazing vinyl
• Heavy-wall aluminum rails/stiles (clear anodized)
• Heavy-duty deadbolt (Grade 1, UL Listed, ANSI/BHMA certified)
• ADA hydraulic door closer (Grade 1, UL Listed, ANSI/BHMA A156.4 compliant)
• Heavy-duty pivot hinges (top and bottom; ANSI/BHMA certified)
• Solid aluminum pull (interior) and push bar (exterior) set (ANSI/BHMA A156.6 compliant)
• Fastener kit for storefront hardware components

All primary hardware components are Grade 1, UL Listed, and ANSI/BHMA certified.

Compliance & Certifications

• ADA compliant approach, clearances, and operability
• IBC compliant storefront entrance assembly
• UL Listed and ANSI/BHMA Grade 1 hardware
• Commercial tempered safety glass

Wall Type & Mounting (Steel Stud Wall with Veneer)

Designed for exterior steel stud framing with a veneer façade (brick, stone, stucco, or panel). Provide continuous structural backing at jambs and head; coordinate flashing and waterproofing with the façade system.

• Anchor into studs/headers with engineered fasteners (by installer)
• Shim at manufacturer-recommended points to maintain plumb/square
• Seal perimeter with commercial-grade backer rod and sealant
• Verify smooth swing and ADA approach clearances

Anchoring fasteners into studs are not included, allowing installers to select the correct type, length, and thread to match stud gauge and header design.

Specifications

• Opening Fit: 39-1/2" wide x 86" tall
• Handing: LH
• Glazing: 1/4" tempered safety glass, pre-glazed
• Rails/Stiles: Heavy-wall aluminum, clear anodized
• Hardware: Grade 1 UL Listed, ANSI/BHMA certified (closer, deadbolt, pivots, pull/push hardware)
• Use: Exterior storefront entries on steel stud wall with veneer
• Origin: Made in USA
• Lead Time: 3–4 week production

Quality & Packaging

• Factory pre-glazing and hardware prep to reduce install time
• Protective wrapping and crating for freight transit
• Installation instructions included

Notes

• Verify rough opening, stud layout, veneer details, and waterproofing plan prior to ordering
• Coordinate threshold/transition with exterior grade and ADA requirements
• Site conditions may require alternate anchors or sealants (by installer)