Compliance & Certifications

• ADA compliant approach, clearances, and operability
• IBC compliant storefront entrance assembly
• Hardware:Grade 1, UL Listed, and ANSI/BHMA certified (e.g., A156.4 closers, A156.5 locks/latches, A156.6 architectural trim)
• Glazing: 1/4" tempered safety glass suitable for commercial storefront use

Key Features

• Narrow stile construction:2" vertical stiles for slim sightlines (light-duty, low-traffic)
• Door size: 36" x 84" (LH handing)
• Glazing: 1/4" tempered safety glass, factory pre-glazed
• Finish: clear anodized, architectural-grade aluminum
• Purpose-built for exterior brick wall openings

What’s Included (Pre-Installed / Packaged)

• Alumitrex™ narrow stile storefront door leaf, 36" x 84", LH
• 1/4" tempered safety glass, factory pre-glazed with commercial glazing vinyl
• Heavy-wall aluminum rails and 2" stiles (clear anodized)
• Deadbolt lock (Grade 1, UL Listed, ANSI/BHMA certified)
• ADA hydraulic door closer (Grade 1, UL Listed, ANSI/BHMA A156.4 compliant)
• Pivot hinges (top and bottom; ANSI/BHMA certified)
• Exterior: Solid aluminum pull | Interior:push bar (ANSI/BHMA A156.6 compliant)
• Fastener kit for storefront hardware components

All primary hardware components are Grade 1, UL Listed, and ANSI/BHMA certified for dependable operation.

Wall Type & Mounting (Exterior Brick Wall)

Designed for brick masonry substrates (solid brick or brick veneer with structural backup). Typical installation uses masonry-rated anchors at jambs and threshold (selected by the installer to match site conditions). Ensure the substrate is plumb, level, and structurally sound prior to installation.

• Anchor with appropriate masonry fasteners at manufacturer-recommended points
• Shim to maintain plumb, level, and square during fastening
• Seal perimeter with commercial-grade backer rod and sealant; coordinate sill/threshold flashing
• Verify smooth swing, latch engagement, and ADA approach clearances

Masonry anchors are not included, allowing the installer to select the correct diameter and embedment for the project’s brick and backup conditions.

Specifications

• Nominal Size: 36" x 84"
• Handing: LH
• Stile Width:2" vertical stiles (narrow stile)
• Glazing: 1/4" tempered safety glass, pre-glazed
• Material/Finish: heavy-wall aluminum, clear anodized
• Hardware: Grade 1 UL Listed, ANSI/BHMA certified (closer, lock, pivots, pull/push)
• Use: light-duty, low-traffic commercial entrances
• Origin: Made in USA
• Production: 3–4 week lead time

Quality & Packaging

• Factory pre-glazing and hardware prep to reduce install time
• Protective wrapping and heavy-duty crating for freight transit
• Installation instructions included

Notes

• Verify rough opening, brick condition, and backup structure prior to ordering
• Coordinate threshold transition and waterproofing details with site conditions
• Site-specific conditions may require alternate anchors or sealants (by installer)