DC USA Approved PD15-M-CVR Electrified Concealed Vertical Rod Exit Device With Motorized Latch Retraction (Jackson 1285 and Kawneer 1686 Replica)
The PD15/16 is a complete retrofit storefront exit device series for the Kawneer 1686/1786 & Jackson 1285/1295.It's made for use in all institutions and commercial buildings storefront applications. Install this device with the confidence of knowing that the PD15/16 series meets or exceeds the high standards of other grade 1 products. In retrofit situations you can utilize the existing hardware (i.e vertical rods) with no additional prep required.
The DC USA Approved PD15-M series is a motorized latch pullback Grade 1 storefront exitdevice; made for use in all institutions and commercial buildings storefront applications.All PD15-M models are equipped with our PTS "push to set" technology. As a retrofit for theJackson 1285/95 & Kawneer 1686/1786 series models are designed to utilize the existingmounting locations and mortise or rod & case assemblies without having to remove the door.Install this device with the confidence of knowing that the PD15-M series meets or exceeds thehigh standards of other grade 1 products.
Specifications: Electronics
System protection - unit shutdown when voltage exceeds 28VDC
Standard - Average Current Peak: 1.3A, Average Current Hold: 170mA
High Torque - Average Current Peak: 2A, Average Current Hold: 250mA
PTS adjustment - approx. 1/4"
300' Run w/ 18ga
Features:
Our motorized latch retraction is fast, quiet, and smooth!
MM4 Smart Module: On board diagnostics with audible feedback for adjustment and power issues
"PTS": 5 second electronic adjustment for easy post installation adjustment
Electric dogging rated for continuous duty - Auto re-engage if pulled from the dogged position
Low current draw: Compatible with most 24VDC, 1A (or greater) regulated & linear power supplies
Up to 300' with 2-18ga --Long wire runs with provides installer with convenience of placing the locking devicepower supply in a centralized location; i.e. the same closet as the access panel
8' cable with Quick Connect for MM4 module to easily connect to power supply lead
The slim, compact attractive low profile design enables mounting on narrow-style doors.
Maintains factory dogging
Hardware: Handing
Please specify handing.
Pushbar Length
Standard sizes: dimensioned for 36" and 48" openings. Standard width bars can be field cut to the next smallest opening width.
48" & 36" - Cutdown all the way to the pushpad
Door Thickness
Suits 1-3/4" standard
Projection
2-5/8" when fully projected, 1-5/8"when dogged.
Stile Width
Minimum 2" Stile. Fits narrow, medium, and wide stile aluminum doors.
Dogging
Standard dogging with hex key or cylinder dogging option. Electric dogging also available.
Fasteners
Standard self-tapping screws
Vertical Rods
Top and bottom steel rods for easy adjustment
Standard device is adjustable for nominal door heights
