DC USA Approved PD15-M-RIM Electrified Rim Exit Device With Motorized Latch Retraction (Jackson 1295 and Kawneer 1786 Replica)

The PD15/16 is a complete retrofit storefront exit device series for the Kawneer 1686/1786 & Jackson 1285/1295.It's made for use in all institutions and commercial buildings storefront applications. Install this device with the confidence of knowing that the PD15/16 series meets or exceeds the high standards of other grade 1 products. In retrofit situations you can utilize the existing hardware (i.e vertical rods) with no additional prep required.

The DC USA Approved PD15-M series is a motorized latch pullback Grade 1 storefront exitdevice; made for use in all institutions and commercial buildings storefront applications.All PD15-M models are equipped with our PTS "push to set" technology. As a retrofit for theJackson 1285/95 & Kawneer 1686/1786 series models are designed to utilize the existingmounting locations and mortise or rod & case assemblies without having to remove the door.Install this device with the confidence of knowing that the PD15-M series meets or exceeds thehigh standards of other grade 1 products.


Specifications:
Electronics

• System protection - unit shutdown when voltage exceeds 28VDC
• Standard - Average Current Peak: 1.3A, Average Current Hold: 170mA
• High Torque - Average Current Peak: 2A, Average Current Hold: 250mA
• PTS adjustment - approx. 1/4"
• 300' Run w/ 18ga

Features:

• Our motorized latch retraction is fast, quiet, and smooth!
• MM4 Smart Module: On board diagnostics with audible feedback for adjustment and power issues
• "PTS": 5 second electronic adjustment for easy post installation adjustment
• Electric dogging rated for continuous duty - Auto re-engage if pulled from the dogged position
• Low current draw: Compatible with most 24VDC, 1A (or greater) regulated & linear power supplies
• Up to 300' with 2-18ga --Long wire runs with provides installer with convenience of placing the locking devicepower supply in a centralized location; i.e. the same closet as the access panel
• 8' cable with Quick Connect for MM4 module to easily connect to power supply lead
• The slim, compact attractive low profile design enables mounting on narrow-style doors.
• Maintains factory dogging

Hardware:
Handing

• Device is non-handed.

Pushbar Length

• Standard sizes: dimensioned for 36" and 48" openings. Standard width bars can be field cut to the next smallest opening width.
• 48" & 36" - Cutdown all the way to the pushpad

Door Thickness

• Suits 1-3/4" standard

Projection

• 2-5/8" when fully projected, 1-5/8"when dogged.

Stile Width

• Minimum 2" Stile. Fits narrow, medium, and wide stile aluminum doors.

Dogging

• Standard dogging with hex key or cylinder dogging option. Electric dogging also available.

Fasteners

• Standard self-tapping screws

Vertical Rods

• Top and bottom steel rods for easy adjustment
• Standard device is adjustable for nominal door heights